MB Screed System

System components

1.	MB Euro Systempipe 12 or 17
2.	MB Steel Clipsrail 12 or 17
3.	MB heat screed with mortar and screed emulsion MB PVP or MB Typ E
4.	MB PE foil 0.2 mm
5.	Insulation in accordance with the valid EnEV or DIN/EN
6.	Edge insulation band (minimum thickness 10 mm)
7.	Surface floorcovering
8.	Wall plaster
9.	Rough brickwork

Applications

For use in residential and commercial buildings using standard screeds and heat requirement which comply with EnEV, up to load capacities of 2.0 kN/m². The load capacity can be increased by increasing the depth of screed as specified under the terms of planning or by the structural engineer in charge.

(Download MB Screed System)

MB Screed Flat System

System components

1.	MB Euro Systempipe 12 or 17
2.	MB Steel Clipsrail 12 or 17
3.	MB special heat screed
4.	Special steel fibres
5.	MB PE foil 0.2 mm
6.	Insulation in accordance with the valid EnEV or DIN/EN
7.	Edge insulation band (minimum thickness 10 mm)
8.	Surface floorcovering
9.	Wall plaster
10.	Rough brickwork

Applications

MB Screed System variant with a low as possible structure height. The MB Screed-Flat System is designed for load capacities of 3.5 kN/m². In order to increase these load capacities, e.g. up to 5.0 kN/m², a construction height of 50 mm is recommended. With this system, the bending tensile strength is higher than with a non-treated screed.

(Download MB Screed-Flat System)

MB Wall System

System components

1.	MB Euro Systempipe 12 or 17
2.	MB Steel Clipsrail 12 or 17
3.	Steel mesh (with apertures of 0.5 cm) or equivalent plastic fabric
4.	Stainless steel fixing screws and rawl plugs to secure the MB Steel Clipsrail
5.	Cement-based screed or lime-gypsum plaster if specified, with minimum 1 cm cover over steel/fabric 03. above
6.	Insulation board, minimum PUR 20 mm (for external walls adhere to latest EnEV, R_λ=2,0 m²K/W)
7.	Wall

Applications

A stand alone heating solution for new build projects where underfloor heating cannot be used for reasons of architecture. The MB Wall System also provides an optimal solution for floors that are subjected to particularly high thermal strains, or for other system requirements.

(Download MB-Wandsystem)

Previous ← → Next